Huawei quidway s7700 - Setting the Packet Matching Rule; Adding an Outer VLAN Tag

Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The interface view is displayed.
Step 3 Run:
port link-type hybrid
The type of the interface is set to hybrid.
By default, the interface type is hybrid.
----End
5.5.3 Setting the Packet Matching Rule
Context
Do as follows on the S7700 where you need to configure selective QinQ.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
traffic classifier classifier-name
A traffic classifier is created and the traffic classifier view is displayed.
Step 3 Run:
if-match vlan-id start-vlan-id [ to end-vlan-id ]
The packet matching rule, that is, the range of VLAN IDs of packets matching the classifier, is
set.
----End
5.5.4 Adding an Outer VLAN Tag
Context
Do as follows on the S7700 where you need to configure selective QinQ.
Quidway S7700 Smart Routing Switch
Configuration Guide - Ethernet 5 QinQ Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
196