Huawei quidway s7700 - Configuring the Type of an Interface; Setting the Protocol Type in the Outer VLAN Tag

Applicable Environment
To enable the S7700 to communicate with devices of other vendors, you need to set a protocol
type that can be identified by the peer device in the outer VLAN tag.
Pre-configuration Tasks
None.
Data Preparation
To set the protocol type in the outer VLAN tag, you need the following data.
No. Data
1 Interface number
2 Protocol type in the outer VLAN tag
5.7.2 Configuring the Type of an Interface
Context
Do as follows on the S7700 where you need to set the protocol type in the outer VLAN tag.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The interface view is displayed.
Step 3 Run:
port link-type { hybrid | trunk | access }
The interface type is configured.
By default, the interface type is hybrid.
----End
5.7.3 Setting the Protocol Type in the Outer VLAN Tag
Context
Do as follows on the S7700 where you need to set the protocol type in the outer VLAN tag.
Quidway S7700 Smart Routing Switch
Configuration Guide - Ethernet 5 QinQ Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
201