Huawei quidway s7700 - Optional) Configuring an Interface to Work at Layer 2 or Layer 3; Checking the Configuration

system-view
The system view is displayed.
Step 2 Run:
interface gigabitethernet interface-number
The GigabitEthernet interface view is displayed.
Step 3 Run:
combo-port { auto | copper | fiber }
The interface is changed to an optical interface or an electrical interface.
By default, a combo port selects the working mode automatically.
A G24C LPU has 8 electrical interface and 24 optical interfaces, among which the first 8 optical
interfaces are duplexed with electrical interfaces. You can use the combo-port command to use
these interfaces as electrical interfaces or optical interfaces.
----End
1.3.8 (Optional) Configuring an Interface to Work at Layer 2 or Layer
3
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The interface view is displayed.
Step 3 Run:
portswitch
The interface is configured to work at Layer 2.
Step 4 Run:
undo portswitch
The interface is configured to work at Layer 3.
By default, an Ethernet interface works at Layer 2.
When an Ethernet interface switches from Layer 3 to Layer 2, the Layer 3 functions and flag
are disabled. The MAC address of the system is used.
----End
1.3.9 Checking the Configuration
Quidway S7700 Smart Routing Switch
Configuration Guide - Ethernet 1 Ethernet Interface Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
7