Huawei quidway s7700 - Optional) Configuring Permanent Vlans; Optional) Configuring the S7700 to Age All the Vlans

The aging time of registered VLANs is set.
By default, the aging time of registered VLANs is 15 seconds.
NOTE
The value of the VLAN registration timer must be smaller than the aging time of registered VLANs. It is
recommended that the aging time of registered VLANs be three times the value of the VLAN registration
timer or larger.
----End
12.3.6 (Optional) Configuring Permanent VLANs
Context
Do as follows on the S7700 where permanent VLANs need to be configured.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
hvrp permanent-vlan { vlan-id1 [ to vlan-id2 ] }&<1-10>
Permanent VLANs are configured.
By default, no VLAN is the permanent VLAN.
Ordinary VLANs on an HVRP interface may be aged, whereas permanent VLANs are never
aged.
You can configure a VLAN as a permanent VLAN only after the VLAN is created.
----End
12.3.7 (Optional) Configuring the S7700 to Age All the VLANs
Context
Do as follows on the S7700 where all the VLANs need to be aged.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
hvrp vlan-age all
The S7700 is enabled to age all the VLANs.
Quidway S7700 Smart Routing Switch
Configuration Guide - Ethernet 12 HVRP Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
619