Huawei quidway s7700 - Creating an Eth-Trunk Sub-Interface; Setting the IP Address of an Eth-Trunk Sub-Interface

No. Data
1 Number of the main interface
2 Number of the sub-interface
3 ID of the VLAN that the sub-interface belongs to
4 Rate of sending gratuitous ARP packets
2.5.2 Creating an Eth-Trunk Sub-interface
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface eth-trunk trunk-id
An Eth-Trunk interface is created and the Eth-Trunk interface view is displayed.
Step 3 Run:
quit
Return to the system view.
Step 4 Run:
interface eth-trunk trunk-id.subnumber
An Eth-Trunk sub-interface is created.
subinterface-number specifies the number of a sub-interface. The value ranges from 1 to 4096.
----End
2.5.3 Setting the IP Address of an Eth-Trunk Sub-interface
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface eth-trunk trunk-id.subnumber
The Eth-Trunk sub-interface view is displayed.
Step 3 Run:
ip address ip-address { mask | mask-length } [ sub ]
The IP address of the sub-interface is set.
Quidway S7700 Smart Routing Switch
Configuration Guide - Ethernet 2 Link Aggregation Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
36