Huawei quidway s7700 - Checking the Configuration; Maintaining HVRP; Debugging HVRP

By default, only local VLANs are aged.
On a network with one or more rings, you can enable the S7700 to age all the VLANs or only
the local VLANs.
----End
12.3.8 Checking the Configuration
Procedure
l Run the display hvrp verbose command to view detailed information about HVRP.
l Run the display hvrp local-vlan command to view information about local VLANs.
----End
Example
Run the display hvrp verbose command, and you can heck whether HVRP is enabled, whether
the function of aging all VLANs is enabled, whether permanent VLANs are configured, and
whether HVRP is enabled on each interface. In addition, you can view the VLAN registration
timer and aging timer of registered VLANs.
<Quidway> display hvrp verbose
HVRP is enabled globally.
HVRP registervlan timer :5s.
HVRP registervlan age timer :15s.
HVRP age all VLAN :Disabled.
HVRP Permanent-vlan :
HVRP statistics on port GigabitEthernet1/0/0 (PORT_LINK_UP)
Mstp Role :
0 - designated
HVRP statistics on port GigabitEthernet2/0/0 (PORT_LINK_UP)
Mstp Role :
0 - root
Run the display hvrp local-vlan command, and you can view information about the local
VLANs.
<Quidway> display hvrp local-vlan
Local Vlan : 3 7 10 40 64
12.4 Maintaining HVRP
This section describes how to maintain HVRP.
12.4.1 Debugging HVRP
Context
When an HVRP fault occurs, run the following debugging commands in the user view to locate
the fault.
Quidway S7700 Smart Routing Switch
Configuration Guide - Ethernet 12 HVRP Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
620