Huawei quidway s7700 - Checking the Configuration; Configuring an Eth-Trunk Sub-Interface; Establishing the Configuration Task

Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
unknown-unicast load-balance { dmac | smac | smacxordmac | enhanced }
The load balancing mode for unknown unicast traffic is configured.
----End
2.4.12 Checking the Configuration
Procedure
l Run the display trunkmembership eth-trunk trunk-id command to display the member
interfaces of the Eth-Trunk.
l Run the display eth-trunk [ trunk-id [interface interface-type interface-number ] ]
command to display information about the Eth-Trunk and member interfaces.
----End
2.5 Configuring an Eth-Trunk Sub-interface
This section describes how to configure an Eth-Trunk sub-interface.
2.5.1 Establishing the Configuration Task
Applicable Environment
When two S7700s communicate with each other through a Layer 2 Eth-Trunk interface, MPLS
TE cannot be enabled on the main interface. In this case, to use the MPLS TE feature, you can
create a sub-interface on the Layer 2 Eth-Trunk interface and enable MPLS TE on the sub-
interface. In this manner, data of Layer 2 and Layer 3 services can be transmitted on the same
physical link.
Pre-configuration Tasks
Before configuring an Eth-Trunk sub-interface, complete the following tasks:
l Creating and configuring a Layer 2 Eth-Trunk interface
l Connecting the S7700s through a physical link
Data Preparation
To configure an Eth-Trunk sub-interface, you need the following data.
Quidway S7700 Smart Routing Switch
Configuration Guide - Ethernet 2 Link Aggregation Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
35