EasyManua.ls Logo

Huawei quidway s7700 - Configuring the Transparent Transmission Mode of Layer 2 Protocol Packets

Huawei quidway s7700
648 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
l Common multicast MAC addresses that have been used on the device
----End
11.5.3 Configuring the Transparent Transmission Mode of Layer 2
Protocol Packets
Context
To implement transparent transmission of Layer 2 protocol packets, replace the default multicast
MAC address of the Layer 2 protocol that can be identified by PEs with another multicast MAC
address or replace the original multicast destination MAC address of Layer 2 protocol packets
from user networks with a specified multicast MAC address.
Use either of the following methods on PEs according to the Layer 2 protocol type and the
required transparent transmission mode.
Procedure
l Replace the default multicast MAC address of the Layer 2 protocol that can be identified
by PEs with another multicast MAC address.
1. Run:
system-view
The system view is displayed.
2. Run:
bpdu-tunnel stp bridge role provider
The PE is configured as a provider.
NOTE
l This method is applicable only to STP, RSTP, and MSTP.
l Replace the original multicast MAC address of Layer 2 protocol packets from user networks
with a specified multicast MAC address.
1. Run:
system-view
The system view is displayed.
2. Run:
l2protocol-tunnel protocol-type group-mac group-mac
The original multicast destination MAC address of Layer 2 protocol packets is
replaced with a specified multicast MAC address.
NOTE
When configuring Layer 2 protocol transparent transmission, do not use the following multicast
MAC addresses to replace the destination MAC address of Layer 2 protocol packets:
l Destination MAC addresses of BPDUs: 0180-C200-0000 to 0180-C200-002F
l Destination MAC address of Smart Link packets: 010F-E200-0004
l Special multicast MAC addresses: 0100-0CCC-CCCC and 0100-0CCC-CCCD
l Common multicast MAC addresses that have been used on the device
----End
Quidway S7700 Smart Routing Switch
Configuration Guide - Ethernet 11 Layer 2 Protocol Transparent Transmission Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
587

Table of Contents

Other manuals for Huawei quidway s7700

Related product manuals