Huawei quidway s7700 - Page 192

Figure 4-1 Networking diagram for configuring VLAN mapping of single VLAN tag
VLAN10
SwitchC
SwitchD
SwitchBSwitchA
GE1/0/1
GE1/0/1
GE3/0/2
GE3/0/1
VLAN6
172.16.0.1/16
172.16.0.2/16 172.16.0.3/16
172.16.0.5/16 172.16.0.6/16 172.16.0.7/16
VLAN5
GE2/0/2
GE1/0/1
GE3/0/1
GE3/0/2
Network
Configuration Roadmap
The configuration roadmap is as follows:
1. Create VLANs on SwitchA, SwitchB, SwitchC, and SwitchD.
2. Add interfaces of SwitchA, SwitchB, SwitchC, and SwitchD to the corresponding VLANs.
3. Configure VLAN mapping of a single tag on GE 1/0/1 of SwitchA.
4. Configure VLAN mapping of a single tag on GE 2/0/2 of SwitchB.
Data Preparation
To complete the configuration, you need the following data:
l VLAN to be created on SwitchA: VLAN 6
l VLAN to be created on SwitchB: VLAN 5
l VLAN to be created on SwitchC and SwitchD: VLAN 10
Procedure
Step 1 Create VLANs on the Switches.
# Create VLAN 6 on SwitchA.
<Quidway> system-view
[Quidway] sysname SwitchA
[SwitchA] vlan 6
# Create VLAN 5 on SwitchB.
Quidway S7700 Smart Routing Switch
Configuration Guide - Ethernet 4 VLAN Mapping Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
175