Data Preparation
To complete the configuration, you need the following data:
l GE1/0/1 of the Switch needs to be added to VLAN 10 and VLAN 20.
l The IP address of VLANIF10 on the Switch is 10.10.10.1/24.
l The IP address of VLANIF20 on the Switch is 20.20.20.1/24.
l GE1/0/1of SwitchA needs to be added to VLAN 10 and VLAN 20.
l GE1/0/2 of SwitchA needs to be added to VLAN 10.
l GE1/0/3 of SwitchA needs to be added to VLAN 20.
Procedure
Step 1 # Configure the Switch.
# Create VLANs.
<Quidway> system-view
[Quidway] vlan batch 10 20
# Add GE1/0/1 to VLANs.
[Quidway] interface gigabitethernet 1/0/1
[Quidway-GigabitEthernet1/0/1] port link-type trunk
[Quidway-GigabitEthernet1/0/1] port trunk allow-pass vlan 10 20
[Quidway-GigabitEthernet1/0/1] quit
# Assign IP addresses to VLANIF interfaces.
[Quidway] interface vlanif 10
[Quidway-Vlanif10] ip address 10.10.10.1 24
[Quidway-Vlanif10] quit
[Quidway] interface vlanif 20
[Quidway-Vlanif20] ip address 20.20.20.1 24
[Quidway-Vlanif20] quit
Step 2 Configure SwitchA.
# Create VLANs.
<Quidway> system-view
[Quidway] vlan batch 10 20
# Add interfaces to VLANs.
[Quidway] interface gigabitethernet 1/0/1
[Quidway-GigabitEthernet1/0/1] port link-type trunk
[Quidway-GigabitEthernet1/0/1] port trunk allow-pass vlan 10 20
[Quidway-GigabitEthernet1/0/1] quit
[Quidway] interface gigabitethernet 1/0/2
[Quidway-GigabitEthernet1/0/2] port link-type access
[Quidway-GigabitEthernet1/0/2] port default vlan 10
[Quidway-GigabitEthernet1/0/2] quit
[Quidway] gigabitethernet 1/0/3
[Quidway-GigabitEthernet1/0/2] port link-type access
[Quidway-GigabitEthernet1/0/2] port default vlan 20
[Quidway-GigabitEthernet1/0/3] quit
Step 3 Verify the configuration.
On PC1 in VLAN 10, set the default gateway address to 10.10.10.1/24, which is the IP address
of VLANIF10.
Quidway S7700 Smart Routing Switch
Configuration Guide - Ethernet 3 VLAN Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
130
To Next Page
Loading...
