Huawei quidway s7700 - Page 16

11.4.5 Checking the Configuration.................................................................................................................585
11.5 Configuring QinQ-based Layer 2 Protocol Transparent Transmission........................................................585
11.5.1 Establishing the Configuration Task...................................................................................................585
11.5.2 (Optional) Defining Characteristic Information About a Layer 2 Protocol........................................586
11.5.3 Configuring the Transparent Transmission Mode of Layer 2 Protocol Packets.................................587
11.5.4 Enabling QinQ-based Layer 2 Transparent Transmission on an Interface..........................................588
11.5.5 Checking the Configuration.................................................................................................................588
11.6 Maintaining Layer 2 Protocol Transparent Transmission............................................................................589
11.6.1 Debugging Layer 2 Protocol Transparent Transmission.....................................................................589
11.7 Configuration Examples...............................................................................................................................589
11.7.1 Example for Configuring Interface-based Layer 2 Protocol Transparent Transmission.....................589
11.7.2 Example for Configuring VLAN-based Layer 2 Protocol Transparent Transmission........................596
11.7.3 Example for Configuring QinQ-based Layer 2 Protocol Transparent Transmission..........................602
12 HVRP Configuration..............................................................................................................610
12.1 HVRP Overview...........................................................................................................................................611
12.2 HVRP Features Supported by the S7700.....................................................................................................612
12.3 Enabling HVRP............................................................................................................................................615
12.3.1 Establishing the Configuration Task...................................................................................................615
12.3.2 Enabling HVRP Globally....................................................................................................................617
12.3.3 Enabling HVRP on an Interface..........................................................................................................617
12.3.4 (Optional) Setting the VLAN Registration Timer...............................................................................618
12.3.5 (Optional) Setting the Aging Time of Registered VLANs..................................................................618
12.3.6 (Optional) Configuring Permanent VLANs........................................................................................619
12.3.7 (Optional) Configuring the S7700 to Age All the VLANs.................................................................619
12.3.8 Checking the Configuration.................................................................................................................620
12.4 Maintaining HVRP.......................................................................................................................................620
12.4.1 Debugging HVRP................................................................................................................................620
12.5 Configuration Examples...............................................................................................................................621
12.5.1 Example for Configuring HVRP.........................................................................................................621
13 Loop Detection Configuration..............................................................................................624
13.1 Introduction to Loop Detection....................................................................................................................625
13.2 Configuring Loop Detection.........................................................................................................................625
13.2.1 Establishing the Configuration Task...................................................................................................625
13.2.2 Enabling Loop Detection Globally......................................................................................................626
13.2.3 Enabling Loop Detection in a VLAN..................................................................................................626
13.2.4 Enabling Loop Detection Control on an Interface...............................................................................627
13.2.5 (Optional) Disabling Loop Detection on an Interface.........................................................................628
13.2.6 (Optional) Setting the Loop Detection Interval on an Interface..........................................................628
13.2.7 (Optional) Setting the Recovery Time of a Blocked Interface............................................................628
13.2.8 Checking the Configuration.................................................................................................................629
13.3 Configuration Examples...............................................................................................................................630
Quidway S7700 Smart Routing Switch
Configuration Guide - Ethernet Contents
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
xv