Figure 3-22 Networking diagram of a voice VLAN in manual mode
Switch
Internet
DHCP Server
HSI VoIP IPTV
GE1/0/1
LAN Switch
Configuration Roadmap
The configuration roadmap is as follows:
1. Create VLANs.
2. Configure the link type and default VLAN of the interface.
3. Enable the voice VLAN on the interface.
4. Set the mode of adding the interface to the voice VLAN to manual.
5. Set the OUI of the voice VLAN.
6. Set the working mode of the voice VLAN.
7. Add the interface to the voice VLAN.
Data Preparation
To complete the configuration, you need the following data:
l Voice VLAN and VLAN through which the IP phone applies for an IP address: VLAN 2
and VLAN 6
l OUI and mask: 0011-2200-0000 and ffff-ff00-0000
l Default VLAN of GigabitEthernet1/0/1: VLAN 6
Procedure
Step 1 Create VLANs and configure the interface on the Switch.
# Create VLAN 2 and VLAN 6.
Quidway S7700 Smart Routing Switch
Configuration Guide - Ethernet 3 VLAN Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
151
To Next Page
Loading...
