Huawei quidway s7700 - Page 184

A traffic classifier is created and the traffic classifier view is displayed.
3. Run:
if-match vlan-id vlan-id1
The packet matching rule, that is, the outer VLAN ID of packets matching the
classifier, is set.
4. Run:
if-match cvlan-id vlan-id2
The packet matching rule, that is, the inner VLAN IDs of packets matching the
classifier, is set.
5. Run:
quit
Return to the system view.
6. Run:
traffic behavior behavior-name1
A traffic behavior is created and the traffic behavior view is displayed.
7. Run:
remark vlan-id vlan-id3
The S7700 is configured to replace the outer VLAN ID of the packets matching the
traffic classifier with the specified VLAN ID.
8. Run:
remark cvlan-id vlan-id4
The S7700 is configured to replace the inner VLAN ID of the packets matching the
traffic behavior with the specified VLAN ID.
9. Run:
quit
Return to the system view.
10. Run:
traffic policy policy-name1
A traffic policy is created and the policy view is displayed.
11. Run:
classifier classifier-name1 behavior behavior-name1
The classifier is bound to the traffic behavior in the traffic policy.
12. Run:
quit
Return to the system view.
13. Run:
interface interface-type interface-number
The interface view is displayed.
14. Run:
port link-type trunk
The link type of the interface is set to trunk.
Quidway S7700 Smart Routing Switch
Configuration Guide - Ethernet 4 VLAN Mapping Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
167