# Configure PE2.
[PE2] vsi a2 static
[PE2-vsi-a2] pwsignal ldp
[PE2-vsi-a2-ldp] vsi-id 2
[PE2-vsi-a2-ldp] peer 1.1.1.9
Step 8 Bind VSIs to interfaces on PEs.
# Configure PE1.
[PE1] interface gigabitethernet 1/0/0.1
[PE1-GigabitEthernet1/0/0.1] control-vid 1000 qinq-termination
[PE1-GigabitEthernet1/0/0.1] qinq termination pe-vid 100 ce-vid 10
[PE1-GigabitEthernet1/0/0.1] l2 binding vsi a2
[PE1-GigabitEthernet1/0/0.1] quit
# Configure PE2.
[PE2] interface gigabitethernet 2/0/0.1
[PE2-GigabitEthernet2/0/0.1] control-vid 2000 qinq-termination
[PE2-GigabitEthernet2/0/0.1] qinq termination pe-vid 100 ce-vid 10
[PE2-GigabitEthernet2/0/0.1] l2 binding vsi a2
[PE2-GigabitEthernet2/0/0.1] quit
Step 9 Assign IP addresses to VLANIF interfaces on the CEs.
# Configure CE1.
<Quidway> sysname CE1
[CE1] interface vlanif 10
[CE1-Vlanif10] ip address 10.1.1.1 255.255.255.0
[CE1-Vlanif10] quit
# Configure CE2.
<Quidway> sysname CE2
[CE2] interface vlanif 10
[CE2-Vlanif10] ip address 10.1.1.2 255.255.255.0
[CE2-Vlanif10] quit
Step 10 Verify the configuration.
After the configuration, run the display vsi name a2 verbose command on PE1, and you can
find that VSI a2 sets up a PW to PE2, and the status of the VSI is Up.
<PE1> display vsi name a2 verbose
***VSI Name : a2
Administrator VSI : no
Isolate Spoken : disable
VSI Index : 0
PW Signaling : ldp
Member Discovery Style : static
PW MAC Learn Style : unqualify
Encapsulation Type : vlan
MTU : 1500
Mode : uniform
Service Class : --
Color : --
DomainId : 0
Domain Name :
VSI State : up
VSI ID : 2
*Peer Router ID : 3.3.3.9
VC Label : 23552
Peer Type : dynamic
Session : up
Quidway S7700 Smart Routing Switch
Configuration Guide - Ethernet 5 QinQ Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
276
To Next Page
Loading...
