EasyManua.ls Logo

Huawei quidway s7700 - Page 320

Huawei quidway s7700
648 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
1. On the backbone network, configure VPN instances on the PEs connected to CEs and bind
related VPNs to the interfaces connected to the CEs. Then, assign IP addresses to the
interfaces connected to the CEs.
2. Configure OSPF between the PEs to implement interworking between PEs.
3. Configure basic MPLS functions and MPLS LDP and create MPLS LSPs.
4. Configure MP-IBGP for exchanging VPN routing information.
5. Configure EBGP between the CE and the PE to exchange VPN routing information.
6. Configure the Dot1q sub-interface to access the L3VPN on the interface connecting the PE
and CE.
Data Preparation
To complete the configuration, you need the following data:
l IDs of the VLANs that the interfaces belong to, as shown in Figure 5-16
l IP addresses of VLANIF interfaces, as shown in Figure 5-16
l MPLS LSR-IDs of PEs and P
l RDs of VPN-A and VPN-B
l VPN targets of received and sent routes of VPN-A and VPN-B
l Encapsulation mode and VLAN ID of the sub-interface
Procedure
Step 1 Configure an IGP on the MPLS backbone network so that the PE and P can interwork with each
other.
# Configure PE1.
<Quidway> system-view
[Quidway] sysname PE1
[PE1] interface loopback 1
[PE1-LoopBack1] ip address 1.1.1.9 32
[PE1-LoopBack1] quit
[PE1] vlan batch 30
[PE1] interface GigabitEthernet 3/0/0
[PE1-GigabitEthernet3/0/0]port hybrid pvid vlan 30
[PE1-GigabitEthernet3/0/0]port hybrid untagged vlan 30
[PE1-GigabitEthernet3/0/0] quit
[PE1] interface vlanif 30
[PE1-Vlanif30] ip address 172.1.1.1 24
[PE1-Vlanif30] quit
[PE1] ospf
[PE1-ospf-1] area 0
[PE1-ospf-1-area-0.0.0.0] network 172.1.1.0 0.0.0.255
[PE1-ospf-1-area-0.0.0.0] network 1.1.1.9 0.0.0.0
[PE1-ospf-1-area-0.0.0.0] quit
[PE1-ospf-1] quit
# Configure P.
<Quidway> system-view
[Quidway] sysname P
[P] interface loopback 1
[P-LoopBack1] ip address 2.2.2.9 32
[P-LoopBack1] quit
[P] vlan batch 30 60
[P] interface GigabitEthernet 1/0/0
[P-GigabitEthernet1/0/0] port hybrid pvid vlan 30
Quidway S7700 Smart Routing Switch
Configuration Guide - Ethernet 5 QinQ Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
303

Table of Contents

Other manuals for Huawei quidway s7700

Related product manuals