[LSW4-sep-segment1] control-vlan 10
[LSW4-sep-segment1] quit
l Configure a SEP segment with the ID of 2 and a control VLAN with the ID of 10.
# Configure LSW1.
[LSW1] sep segment 2
[LSW1-sep-segment2] control-vlan 10
[LSW1-sep-segment2] quit
# Configure LSW2.
[LSW2] sep segment2
[LSW2-sep-segment2] control-vlan 10
[LSW2-sep-segment2] quit
# Configure LSW3.
[LSW3] sep segment 2
[LSW3-sep-segment2] control-vlan 10
[LSW3-sep-segment2] quit
# Configure LSW4.
[LSW4] sep segment 2
[LSW4-sep-segment2] control-vlan 10
[LSW4-sep-segment2] quit
NOTE
l The control VLAN must be a new one.
l The command used to create a common VLAN is automatically displayed in a configuration file.
l Each SEP segment must be configured with a control VLAN. After being added to a SEP segment
configured with a control VLAN, an interface is added to the control VLAN automatically. You do
not need to run the port trunk allow-pass vlan command. In the configuration file, the port trunk
allow-pass vlan command, however, is displayed in the view of the interface added to the SEP segment.
Step 2 Configure SEP protected instances, and then configure mappings between SEP protected
instances and user VLANs.
# Configure LSW1.
[LSW1] vlan batch 100 to 500
[LSW1] sep segment 1
[LSW1-sep-segment1] protected-instance 1
[LSW1-sep-segment1] quit
[LSW1] sep segment 2
[LSW1-sep-segment2] protected-instance 2
[LSW1-sep-segment2] quit
[LSW1] stp region-configuration
[LSW1-mst-region] instance 1 vlan 100 to 300
[LSW1-mst-region] instance 2 vlan 301 to 500
[LSW1-mst-region] active region-configuration
[LSW1-mst-region] quit
The configurations of LSW2 to LSW4 are similar to those of LSW1, and are not provided here.
For details, see configuration files in this configuration example.
Step 3 Add all the devices on the ring network to the SEP segments and configure interface roles.
NOTE
By default, STP is enabled on a Layer 2 interface. Before adding an interface to a SEP segment, disable
STP on the interface.
# On LSW1, configure GE 1/0/1 as the primary edge interface and GE 1/0/3 as the secondary
edge interface.
[LSW1] interface gigabitethernet 1/0/1
[LSW1-GigabitEthernet1/0/1] stp disable
[LSW1-GigabitEthernet1/0/1] sep segment 1 edge primary
[LSW1-GigabitEthernet1/0/1] sep segment 2 edge primary
[LSW1-GigabitEthernet1/0/1] quit
[LSW1] interface gigabitethernet 1/0/3
Quidway S7700 Smart Routing Switch
Configuration Guide - Ethernet 10 SEP Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
564
To Next Page
Loading...
