Huawei quidway s7700 - Page 633

Figure 12-4 Networking diagram of HVRP application
SwitchE
ME60
SwitchA
SwitchB
SwitchC
SwitchD
VLAN:101-500
VLAN:201-300VLAN:101-200
VLAN:301-400
VLAN:401-500
Pre-configuration Tasks
Before enabling HVRP, complete the following tasks:
l Configuring the interfaces where HVRP needs to be enabled as trunk interfaces
l Enabling STP globally
l Creating VLANs that need to be configured as permanent VLANs
l Deleting MSTP multi-instance
Data Preparation
To enable HVRP, you need the following data.
No.
Data
1 Type and number of the interface where HVRP needs to be enabled
2 Value of the VLAN registration timer
3 Aging time of registered VLANs
4 IDs of the VLANs that need to be configured as permanent VLANs
Quidway S7700 Smart Routing Switch
Configuration Guide - Ethernet 12 HVRP Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
616