The system view is displayed.
Step 2 Run:
vlan vlan-id
A VLAN is created, and the VLAN view is displayed. If the specified VLAN has been created,
the VLAN view is directly displayed.
The VLAN ID ranges from 1 to 4094. If VLANs need to be created in batches, run the vlan
batch { vlan-id1 [ to vlan-id2 ] } &<1-10> command to create VLANs in batches, and then run
the vlan vlan-id command to enter the view of a specified VLAN.
Step 3 Run:
quit
The system view is displayed.
Step 4 Configure the port type and features.
1. Run the interface interface-type interface-number command to enter the view of an
Ethernet port to be added to the VLAN.
2. Run the port link-type { access | hybrid | trunk | dot1q-tunnel } command to configure
the port type.
By default, the port type is hybrid.
l If a Layer 2 Ethernet port is directly connected to a terminal, set the port type to access
or hybrid. Setting the port type to access is recommended.
l If a Layer 2 Ethernet port is connected to another switch, the port type can be set to
access, trunk, hybrid, or QinQ. Setting the port type to trunk is recommended.
Step 5 Add ports to the VLAN.
Run either of the following commands as needed:
l For access or QinQ ports:
Run the port default vlan vlan-id command to add a port to a specified VLAN.
To add ports to a VLAN in batches, run the port interface-type { interface-number1 [ to
interface-number2 ] } &<1-10> command in the VLAN view.
l For trunk ports:
– Run the port trunk allow-pass vlan { { vlan-id1 [ to vlan-id2 ] } &<1-10> | all }
command to add the port to specified VLANs.
– (Optional) Run the port trunk pvid vlan vlan-id command to specify the default VLAN
for a trunk interface.
l For hybrid ports:
– Run either of the following commands to add a port to VLANs in untagged or tagged
mode:
– Run the port hybrid untagged vlan { { vlan-id1 [ to vlan-id2 ] } &<1-10> | all }
command to add a port to VLANs in untagged mode.
In untagged mode, a port removes tags from frames and then forwards the frames.
This is applicable to scenarios in which Layer 2 Ethernet ports are connected to
terminals.
– Run the port hybrid tagged vlan { { vlan-id1 [ to vlan-id2 ] } &<1-10> | all }
command to add a port to VLANs in tagged mode.
Quidway S7700 Smart Routing Switch
Configuration Guide - Ethernet 3 VLAN Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
79
To Next Page
Loading...
