IBM V7000

516 IBM Flex System V7000 Storage Node Introduction and Implementation Guide
Figure 12-5 Check WWPN for WIN 2012 Host definition
4. Check adapters are all functioning with the datapath query adapter command as shown
in Example 12-2 where the output shows both adapters in a normal state and active.
Example 12-2 Datapath query adapter command
PS C:\Users\Administrator> cd "C:\Program Files\IBM\SDDDSM"
PS C:\Program Files\IBM\SDDDSM> ./datapath query adapter
Active Adapters :2
Adpt# Name State Mode Select Errors Paths Active
0 Scsi Port1 Bus0 NORMAL ACTIVE 3274 0 4 4
1 Scsi Port2 Bus0 NORMAL ACTIVE 3189 0 4 4
PS C:\Program Files\IBM\SDDDSM>
5. Enter datapath query device and press Enter to see if there are IBM Flex System V7000
Storage Node disks connected to this host. (Example 12-3).
Example 12-3 datapath query device
PS C:\Program Files\IBM\SDDDSM> ./datapath query device
Total Devices : 2
DEV#: 0 DEVICE NAME: Disk2 Part0 TYPE: 2145 POLICY: OPTIMIZED
SERIAL: 6005076000820005200000000000000A
============================================================================
Path# Adapter/Hard Disk State Mode Select Errors
0 Scsi Port1 Bus0/Disk2 Part0 OPEN NORMAL 1047 0
1 Scsi Port1 Bus0/Disk2 Part0 OPEN NORMAL 0 0
WWPNs