Icom IC-E92D - DV Set Mode Items; Digital Code

New
100
12
MENU SCREEN OPERATION
New2001
■ DV set mode items
The following items are selectable for B band.
D Auto reply
This function replies to an individual station call even you are
away from the transceiver.
After a manual transmission (pushing [PTT]), the Auto Reply
setting returns to OFF automatically.
• OFF : No reply is performed even if a call is received.
(default)
• ON : Sets the caller’s call sign and replies to the call
with the programmed own call sign.
• VOICE : Sets caller’s call sign and replies to the call with
the recorded audio in REPLY VOICE memory
of DV VOICE MEMO.
NOTE: When “ON” or “VOICE” is set in the auto reply
function, the power save function
(p. 96) stop functioning
automatically to receive call sign signal properly.
D Digital code
Sets the desired digital code for digital code squelch opera-
tion. Total of 100 codes (00–99) are available. (default: 00)
D DV data TX
During low-speed data operation, auto data transmission
function is available. This function transmits when data has
been input from PC via the [DATA] jack.
(default: PTT)
• PTT : Data from [DATA/SP/MIC] transmits when
[PTT] is pushed. (default)
• AUTO : Data from [DATA/SP/MIC] transmits automati-
cally.
OFF
OFF
ON
ON
VOICE
VOICE
AUTO REPLY
AUTO REPLY
r
OFF
OFF
ON
ON
VOICE
VOICE
AUTO REPLY
AUTO REPLY
r
00
00
DIGITAL CODE
DIGITAL CODE
99
99
DIGITAL CODE
DIGITAL CODE
PTT
PTT
AUTO
AUTO
DV DATA TX
DV DATA TX
PTT
PTT
AUTO
AUTO
DV DATA TX
DV DATA TX
r
r