103
12
MENU SCREEN OPERATION
New2001
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
• RMC : (Default OFF)
Set RMC sentence ON or OFF.
• GGA : (Default ON)
Set GGS sentence ON or OFF.
• GLL : (Default OFF)
Set GLL sentence ON or OFF.
• GSA : (Default OFF)
Set GSA sentence ON or OFF.
• VTG : (Default OFF)
Set VTG sentence ON or OFF.
• GSV : (Default OFF)
Set GSV sentence ON or OFF.
D GPS-A Set mode
Enter GPS-A operation set mode by selecting "GPS-A" in
GPS TX mode, then push [
](5)
‡
. This set mode is available
to set unproto address, data extension, time stamp, GPS-A
symbol and comment.
D Unproto Address
56 characters address can be entered for unproto address.
q Push [
](5)
‡
twice to enter the unproto address edit
mode.
w Rotate [DIAL]
†
to select the desired character.
• The selected character blinks.
• Push [A/a](3) to change the character group from “AB” (alphabeti-
cal characters; capital letters), “ab” (alphabetical characters; lower
case letters), “12” (numbers) and “ !” ” (symbols) in sequence.
• Push [ ](6) to move the cursor right; push [ ](4) to move the
cursor left.
• Push [CLR](1) to erase the selected character, or push and
hold [CLR](1) for 1 sec. to erase all characters following the
cursor.
e Repeat step w until the desired unproto address is pro-
grammed.
r Push [
](5) to program the unproto address and exit the
unproto address edit mode.
t Push [
](4) to return to GPS-A SET MODE screen mode.
UNPROTO ADD
DATA EXTENS
TIME STAMP
GPS-A SYMBO
COMMENT
GPS-A SET MODE
r
UNPROTO ADD
DATA EXTENS
TIME STAMP
GPS-A SYMBO
COMMENT
GPS-A SET MODE
r
API92,DSTA
R*
R*
:SET
:EDIT
CLR:CLR
UNPROTO ADDRESS
:BACK
AB
†
PI92,DSTA
:SET
:SEL
:CUR
CLR:CLR
A/a:CHAR
UNPROTO ADDRESS
To Next Page
Loading...
