Icom IC-E92D - Copying the Call Sign

New
48
7
DV MODE OPERATION
New2001
■ Copying the call sign
D Copying the call sign memory contents
This function is convenient when or modifying a part of the
current call sign.
NOTE: Make sure that the “EDIT RECORD” item in DV
set mode is set to “AUTO” or “SELECT” in advance.
(p. 106)
q During DV mode operation, enter call sign set mode.
• Pushing and holding [CS](9) for 1 sec. is also available to enter
call sign set mode.
• CALL SIGN screen is displayed.
w Rotate [DIAL]
†
to select “UR,” “R1” or “R2” as desired,
then push [
](5)
†
.
e Rotate [DIAL]
†
to select the desired call sign channel to
be copied.
• U01–U60 and R01–R60 are available.
• When “AUTO” is set to “EDIT RECORD” item
r Push [ ](6) to select the call sign programming mode.
• A blank channel is selected automatically.
• The 1st digit of the selected call sign blinks.
t Edit or modify the selected call sign as described in “Sta-
tion call sign programming”
(p. 36) or “Repeater call sign
programming”
(p. 41).
y Push [
](5) to store the edited/modifi ed call sign into the
selected blank channel.
NOTE: The message “FULL” is displayed when no blank
channel is available in station or repeater call sign mem-
ory.
In this case, select the desired call sign channel number
as described in step e is set to “EDIT RECORD” item” at
right.
❮MENU screen❯ ➪ ❮CALL SIGN❯
(Push [MENU/ ]) (Rotate [DIAL]
†
, then push [ ](5)
‡
.)
U21
U21
AB
AB
†
AAAAA
AAAAA
:SET
:SET
:SEL
:SEL
:CUR
:CUR
CLR:CLR
CLR:CLR
A/a:CHAR
A/a:CHAR
0:CQ
0:CQ
YOUR CALL SIGN
YOUR CALL SIGN
r