79
9
MEMORY/CALL CHANNELS
New2001
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
■ Copying memory/call contents
This function transfers a memory channel’s contents to
VFO (or another memory/call channel). This is useful when
searching for signals around a memory channel frequency
and for recalling the offset frequency, subaudible tone fre-
quency etc.
D Memory/call➪VFO
q Select the memory (call) channel to be copied.
➥ Push [MR] or [CALL] to select memory mode or call
channel mode, then rotate [DIAL] to select the desired
channel.
w Push and hold [S.MW](MR) for 1 sec. to enter select
memory write mode.
• 1 short and 1 long beep sound.
• Memory channel number blinks.
e Rotate [DIAL] to select “VFO.”
r Push and hold [S.MW](MR) for 1 sec. to write the selected
channel contents to VFO mode.
• Returns to VFO mode automatically.
Holding [S.MW](MR) for 2 sec. at the step w, will also
copy the memory contents to VFO. In this case, the steps
e and r are not necessary.
D Memory/call➪memory/call
q Select the memory (call) channel to be copied.
➥ Push [MR] or [CALL] to select memory mode or call
channel mode, then rotate [DIAL] to select the desired
memory channel.
w Push and hold [S.MW](MR) for 1 sec. to enter select
memory write mode.
• 1 short and 1 long beep sound.
• Memory channel number blinks.
• Do not hold [S.MW](MR) for more than 2 sec. otherwise the
memory contents will be copied to VFO.
e Rotate [DIAL] to select the target memory (call) channel.
r Push and hold [S.MW](MR) for 1 sec. again to copy.
A
FM
14
870
PSKIP
FM
14
870
011
14
000
FM
VFO
14
870
BANK
:----
MNAME:
SKIP
:OFF
FM
r
011
During memory mode,
rotate [DIAL] to select
memory channel 11 .
Rotate [DIAL] to select
VFO .
Push and hold
for 1 sec.
VFO is selected.
MR
S.MW
B
Push and hold
for 1 sec.
MR
S.MW
B
[EXAMPLE]: Copying memory channel 11 to VFO.
To Next Page
Loading...
Need help?
General
