Icom IC-E92D - 10 Scan Operation; Scan Types

82
NewNew2001
SCAN OPERATION
10
■ Scan types
Scanning searches for signals automatically and makes it
easier to locate new stations for contact or listening pur-
poses.
FULL SCAN (p. 83)
Repeatedly scans all fre-
quencies over the entire
band. Some frequency
ranges are not scanned ac-
cording to the frequency
coverage of the transceiver’s
version.
SELECTED BAND SCAN
(p. 83)
Repeatedly scans all fre-
quencies over the entire se-
lected band.
ALL/SELECTED BANK
SCAN (p. 86)
Repeatedly scans all bank
channels or selected bank
channels. The skip scan is
also available.
FREQUENCY/MEMORY
SKIP FUNCTION (p. 87)
Skips unwanted frequen-
cies or channels that incon-
veniently stop scanning.
This function can be turned
ON and OFF by pushing and
holding [SKIP](5) in either
VFO or memory mode.
PROGRAMMED SCAN
(p. 83)
Repeatedly scans between
two user-programmed fre-
quencies. Used for checking
for frequencies within a speci-
fied range such as repeater
output frequencies, etc.
MEMORY (SKIP) SCAN
(p. 85)
Repeatedly scans memory
channels except those set
as skip channel. Skip chan-
nels can be turned ON and
OFF by pushing and holding
[SKIP](5) in memory mode.
495
kHz
999.990
MHz
Scan
Jump
Band
edge
Band
edge
Scan
Jump
Band
edge
xxA xxB
Band
edge
Scan edges
Scan
Jump
SKIP
SKIP
M 0
M 4
M 1 M 2 M 3
M 5
M 199 M 6
SKIP
SKIP
A99
A03
A00 A01 A02
A04
A98 A05
Band
edge
Band
edge
Scan
SKIP SKIP
Jump
PROGRAMMED LINK SCAN (p. 83)
Repeatedly programmed scans user-programmed frequen-
cies selected at P-LINK items in the menu mode.
BAND MEMORY (SKIP) SCAN (p. 85)
Repeatedly scans memory channels same band as display-
ing band.
MODE MEMORY (SKIP) SCAN (p. 85)
Repeatedly scans memory channels same mode as display-
ing mode.
BANK-LINK SCAN (p. 86)
Repeatedly scans bank channels selected at BANK-LINK
items in the menu mode.