New
36
7
DV MODE OPERATION
New2001
D Station call sign programming
Station call sign must be programmed to call a specifi c sta-
tion as well as for repeater operation in both digital voice and
low-speed data communications.
q Select B band as the main band.
(p. 14)
w Enter “UR” in call sign set mode.
• Pushing and holding [CS](9) for 1 sec. is also available to enter
call sign set mode.
• YOUR CALL SIGN screen is displayed.
e Rotate [DIAL]
†
to select the desired call sign memory,
“U01” to “U60.”
r Push [
](6) to enter call sign programming mode.
• The 1st digit blinks.
t Rotate [DIAL]
†
to select the desired character or code.
• Push [A/a](3) to change the character group from “AB” (alpha-
betical characters; capital letters), “12” (numbers) and “/” (sym-
bols) in sequence.
y Push [ ](6) to select 2nd digit, then rotate [DIAL]
†
to se-
lect the desired character or code.
• Push [ ](6) to move the cursor right; push [ ](4) to move the
cursor left.
• 2nd digit blinks (1st digit stops blinking).
u Repeat the steps t and y to enter the desired station
call sign.
• Up to an 8-digit call sign can be set.
• If an un-necessary character is entered, push [ ](6) or [ ](4)
to select the character, then push [CLR](1) to erase the se-
lected character, or push and hold [CLR](1) for 1 sec. to erase
all characters following the cursor.
i Push [ ](5) to store the programmed call sign and re-
turns to YOUR CALL SIGN screen.
o Push [MENU/
] to return to frequency indication.
CQCQCQ
:SET
:BACK
:SEL
:EDIT
CLR:CLR
YOUR CALL SIGN
r
U01
AB
†
:SET
:SEL
:CUR
CLR:CLR
A/a:CHAR
0:CQ
YOUR CALL SIGN
r
U01
AB
:SET
:SEL
:CUR
CLR:CLR
A/a:CHAR
0:CQ
YOUR CALL SIGN
r
U01
STATION1
:SET
:BACK
:SEL
:EDIT
CLR:CLR
YOUR CALL SIGN
r
❮MENU screen❯ ➪ ❮CALL SIGN❯ ➪ ❮UR❯
(Push [MENU/ ]) (Rotate [DIAL]
†
, then push [ ](5)
‡
.)
To Next Page
Loading...
