35
7
DV MODE OPERATION
New2001
7
y Push [ ](6) to select 2nd digit, then rotate [DIAL]
†
to se-
lect the desired character or code.
• Push [ ](6) to move the cursor right; push [ ](4) to move the
cursor left.
• 2nd digit blinks (1st digit stops blinking).
u Repeat the steps t and y to enter your own call sign.
• Up to a 8-digit of call sign can be set.
• If an unwanted character is entered, push [ ](6) or [ ](4) to
select the character, then push [CLR](1) to erase the selected
character, or push and hold [CLR](1) for 1 sec. to erase all
characters following the cursor.
• When programming a note (up to a 4-digit for operating radio
type or area, etc.), go to step i, otherwise go to step !0.
i Push [ ](6) several times to set the cursor beside “/” indi-
cation.
o Repeat steps t to y to program the desired 4-character
note.
!0 Push [
](5) to store the programmed call sign with note
and returns to MY CALL SIGN screen.
!1 Push [MENU/
] to return to frequency indication.
†
[DIAL] ↔ [ ](2)/[ ](8)
‡
[ ](5) ↔ [ ](6)
1
2
3
4
5
6
8
9
10
11
12
13
14
15
16
17
18
19
M01
MY CALL SIGN
r
:SET
:SEL
:CUR
CLR:CLR
A/a:CHAR
AB
M01
MYCALL
/IC92
:SET
:BACK
:SEL
:EDIT
CLR:CLR
MY CALL SIGN
r
To Next Page
Loading...
