Icom IC-E92D - Connecting to the [DATA;SP;MIC] Jack

137
16
OPTIONS
New2001
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
When connecting the optional HM-174 WATERPROOF
SPEAKER-MICROPHONE, HM-175GPS GPS WATERPROOF
SPEAKER-MICROPHONE or OPC-1799 DATA COMMUNICATION
CABLE, OPC-1797 CONNECTION CABLE to the [DATA/SP/MIC]
jack, follow the procedure below.
• Connecting to the [DATA/SP/MIC] jack
q Remove the rubber cap. from the [DATA/SP/MIC] jack.
w Orient the connector’s flat face and the [DATA/SP/MIC]
jack’s flat face in same direction, (Verifying triangular
mark) then insert it tightly.
e Rotate the threaded connector shell clockwise to tighten
the connector.
• Disconnecting from the [DATA/SP/MIC] jack
q Rotate the threaded connector shell counter-clockwise to
loosen the connector.
w Disconnect the cable from the [DATA/SP/MIC] jack.
e Reattach the rubber cap tightly to the [DATA/SP/MIC] jack.
■ Connecting to the [DATA/SP/MIC] jack
CAUTION!:
Turn power OFF the transceiver before connecting/
disconnecting cable to/from the [DATA/SP/MIC] jack.
Rubber cap
[DATA/SP/MIC] jack
[DATA/SP/MIC] jack (Upside view)
Flat face
Triangular mark
Connector (Side view)
Flat face
Triangular mark
Rotate the fix screw tighten.
No Sound from the inside
speaker when connecting
OPC-1797.