New
52
7
DV MODE OPERATION
New2001
■ Message operation
D TX message programming
TX messages are available for up to 5 channels and each
channel can be programmed with a message of up to 20
characters. Available characters are 0 to 9, A to Z
(capital let-
ters), a to z (lower case letters), some symbols and space.
q Enter “TX MESSAGE” in message/position set mode.
• TX MESSAGE screen is displayed.
w Rotate [DIAL]
†
to select the desired transmit message
channel.
• Ch01 to Ch05 and OFF are available.
• Previously message is displayed if programmed.
e Push [ ](6) to select the message edit condition.
• The 1st digit of the message blinks.
r Rotate [DIAL]
†
to select the desired character or symbol.
• Push [A/a](3) to change the character group from “AB” (alpha-
betical characters; capital letters), “ab” (alphabetical characters;
lower case letters), “12” (numbers) and “ !” ” (symbols) in se-
quence.
• If an un-necessary character is entered, push [ ](6) or [ ](4)
to select the character, then push [CLR](1) to erase the se-
lected character, or push and hold [CLR](1) for 1 sec. to erase
all characters following the cursor.
t Push [ ](6) to select 2nd digit, then rotate [DIAL]
†
to se-
lect the desired character or code.
• Push [ ](6) to move the cursor right; push [ ](4) to move the
cursor left.
• 2nd digit blinks (1st digit stops blinking).
y Repeat the steps r and t to enter the desired message.
• Up to 20-character messages can be set.
u Push [ ](5) to store the message.
i Push [MENU/
] to return to frequency indication.
❮MENU screen❯ ➪ ❮MESSAGE/POSITION❯ ➪ ❮TX MESSAGE❯
(Push [MENU/ ]) (Rotate [DIAL]
†
, then push [ ](5)
‡
.)
Ch01
AB
†
:SET
:SEL
:BACK
CLR:CLR
TX MESSAGE
:EDIT
r
Ch01
!'
Hello!
†
:SET
:SEL
:CUR
CLR:CLR
A/a:CHAR
TX MESSAGE
r
To Next Page
Loading...
