EasyManuals Logo

Icom IC-E92D Instruction Manual

Icom IC-E92D
156 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #140 background imageLoading...
Page #140 background image
132
New2001
TROUBLESHOOTING
14
PROBLEM
No power comes ON.
No sound comes from the
speaker.
Transmitting is impossible.
No contact possible with
another station.
Frequency can not be set.
Program scan function can
not start.
Memory scan function can
not start.
The displayed frequency is
erroneous.
Can not charge the battery
with BC-177 (LED blinks
orange).
If your transceiver seems to be malfunctioning, please check the following points before sending it to a service center.
POSSIBLE CAUSE
The batteries are exhausted.
• Loose connection of a battery pack (case).
The battery polarity is reversed.
Volume level is too low.
External speaker is connected with
OPC-1797.
The batteries are exhausted.
A frequency outside of the 144/430 MHz
amateur bands is set.
Different tone is selected with tone/DTCS
squelch.
The lock function is activated.
Memory mode or call channel is selected.
Memory mode or call channel is selected.
Same frequencies are programmed both
A” and “B” of PROGRAM-CH.
VFO mode or call channel is selected.
The programmed memory channel is only one.
The CPU malfunctioned.
• External factors caused a fault.
The transceiver’s power is ON.
The battery pack is fault electric dis-
charge.
SOLUTION
• Replace the batteries or charge the battery pack.
• Clean battery terminals.
• Check the battery polarity.
• Rotate [VOL] to suitable level.
Check the connection of the external speaker or
OPC-1797 correctly.
• Replace the batteries or charge the battery pack.
Reset the frequency within 144/430 MHz amateur
bands.
• Check the tone/DTCS using tone scan.
Push [MENU/ ] for 1 sec. to cancel the function.
• Push [VFO] to set VFO mode.
• Push [VFO] to set VFO mode.
Programming different frequencies in “A” and “B”
respectively.
• Push [MR] to set memory mode.
• Program more than 2 memory channels.
• Reset the transceiver.
Remove and re-attach the battery pack or battery
case.
Turn the transceiver’s power OFF, or insert only the
battery pack into the BC-177 to charge it.
The battery pack is charged alone (without the trans-
ceiver) or regular charge is carried out.
REF.
pgs. 1, 10–12
p. 12
p. 20
pgs. 1, 10–12
p. 24
p. 126
p. 25
p. 15
p. 15
p. 84
p. 15
pgs. 74, 85
p. 131
p. 1
pgs. 9, 11
New

Table of Contents

Other manuals for Icom IC-E92D

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Icom IC-E92D and is the answer not in the manual?

Icom IC-E92D Specifications

General IconGeneral
BrandIcom
ModelIC-E92D
CategoryTransceiver
LanguageEnglish

Related product manuals