Icom IC-E92D - Scan Resume Condition

■ Scan resume condition
D Scan pause timer
The scan pauses when receiving signals according to the
scan pause time. It can be set from 2 to 20 sec. or unlimited.
q Enter “PAUSE TIMER” in scan set mode.
(p. 108)
w Rotate [DIAL]
†
to set the desired scan pausing time from
2–20 sec. (2 sec. steps) or “HOLD.”
• “2SEC”–“20SEC” : Scan pauses for 2–20 sec. while receiving a
signal.
• “HOLD” : Scan pauses on a received a signal until it
disappears.
e Push [ ](5) (or [ ](4)) to return to scan set mode.
r [MENU/
] to return to frequency indication.
D Scan resume timer
The scan restarts after the signal disappears according to
the resume time. It can be set from 0–5 sec. or unlimited.
q Enter “RESUME TIMER” in scan set mode.
(p. 108)
w Rotate [DIAL]
†
to set the desired scan resume time from
0–5 sec. (1 sec. steps) and “HOLD.”
• “0SEC” : Scan restarts immediately after the signal
disappears.
• “1SEC”–“5SEC” : Scan restarts 1–5 sec. after the signal disap-
pears.
• “HOLD” : Scan restarts by rotating [DIAL] only.
e Push [ ](5) (or [ ](4)) to return to scan set mode.
r [MENU/
] to return to frequency indication.
Scan resume timer must be set shorter than the scan
pause timer, otherwise this timer does not activate.
89
10
SCAN OPERATION
New2001
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
❮MENU screen❯ ➪ ❮SCAN❯ ➪ ❮PAUSE TIMER❯
(Push [MENU/ ]) (Rotate [DIAL]
†
, then push [ ](5)
‡
.)
10SEC
10SEC
6SEC
6SEC
8SEC
8SEC
4SEC
4SEC
12SEC
12SEC
PAUSE TIMER
PAUSE TIMER
r
• Pause timer setting
❮MENU screen❯ ➪ ❮SCAN❯ ➪ ❮RESUME TIMER❯
(Push [MENU/ ]) (Rotate [DIAL]
†
, then push [ ](5)
‡
.)
• Resume timer setting
2SEC
2SEC
4SEC
4SEC
3SEC
3SEC
1SEC
1SEC
5SEC
5SEC
RESUME TIMER
RESUME TIMER
r
†
[DIAL] ↔ [ ](2)/[ ](8)
‡
[ ](5) ↔ [ ](6)