New
46
7
DV MODE OPERATION
New2001
■ Received call sign
When a call is received in DV mode, the calling station and
the repeater call signs being used can be stored into the re-
ceived call record. The stored call signs are viewable in the
following manner.
Up to 20 calls can be recorded.
D Desired call record indication
q Enter RX call sign set mode.
• Pushing and holding [CD](.) for 1 sec. is also available to enter
RX call sign set mode.
• RX CALL SIGN screen is displayed.
w Rotate [DIAL]
†
to select the desired record channel.
e To confirm the received call, push [
](5) several times
to select the desired call sign from CALLER, CALLED,
RXRPT1 and RXRPT2.
CALLER : The station call sign that made a call.
CALLED : The station call sign called by the caller.
RXRPT1 : The repeater call sign used by the caller station.
RXRPT2 : The repeater call sign linked from RXRPT1.
r Push [MENU/ ] to return to frequency indication.
NOTE: When a call is received in DV mode when the
power save function is activated, the call sign may not be
received correctly.
This is normal, not a malfunction, because the call sign
information cannot be detected during power save.
Turn the power save function OFF
(p. 129) if you want to
receive a call sign correctly even in stand-by operation.
✔ For your information
When receiving a call, the received station call sign is auto-
matically displayed and scrolled in sequence at the bottom
line of the function display.
This can be turned OFF in display set mode.
(p.113)
†
[DIAL] ↔ [ ](2)/[ ](8)
‡
[ ](5) ↔ [ ](6)
❮MENU screen❯ ➪ ❮RX CALL SIGN❯
(Push [MENU/ ]) (Rotate [DIAL]
†
, then push [ ](5)
‡
.)
RX01
CALLER:
AAAAAA
/
:CALLED
:SEL
:COPY
CLR:CLR
RX CALL SIGN
r
RX01
CALLED:
CQCQCQ
:RXRPT1
:SEL
:COPY
CLR:CLR
RX CALL SIGN
r
RX01
RXRPT2:
:CALLER
:SEL
:COPY
CLR:CLR
RX CALL SIGN
r
RX01
RXRPT1:
:RXRPT2
:SEL
:COPY
CLR:CLR
RX CALL SIGN
r
Push
• Station call sign • Called station call sign
• Repeater 1 call sign
• Repeater 2 call sign
5
SKIP
To Next Page
Loading...
