Icom IC-E92D - Mode Selection; Vfo Mode

New2001
15
4
FREQUENCY AND CHANNEL SETTING
4
■ Mode selection
D VFO mode
VFO mode is used to set the desired frequency.
➥ Push [VFO] to select VFO mode.
What is VFO?
VFO is an abbreviation of Variable Frequency Oscillator. Fre-
quencies for both transmitting and receiving are generated
and controlled by the VFO.
D Memory mode
Memory mode is used for operation on memory channels
which store programmed frequencies.
q Push [MR] to select memory mode.
• “µ ” appears when memory mode is selected.
w Rotate [DIAL] to select the desired memory channel.
• Only programmed memory channels can be selected.
• Enter the memory channel directly to select the desired memory
channel. (p. 72)
• See p. 74 for memory programming details.
A
A
MemoName
MemoName
µ
PRIO
PRIO
WX
WX
EMR
EMR
DTCS
DTCS
FM
FM
LOW
LOW
ATT
ATT
14
144
000
000
+DUP
+DUP
000
000
PSKIP
PSKIP
• VFO mode indication
VFO
MHz
A
MR
S.MW
B
A
MemoName
MemoName
µ
PRIO
PRIO
WX
WX
EMR
EMR
DTCS
DTCS
FM
FM
LOW
LOW
ATT
ATT
43
433
000
000
PSKIP
PSKIP
+DUP
+DUP
001
001
• Memory mode indication
Appear
Set the attenuator function ON (☞p. 22) if the received
signal is blocked by other radio station when using a third
party high-gain antenna.