Icom IC-E92D - Gps Message Automatic Transmission; Received Gps Message Indication

62
8
GPS/GPS-A OPERATION
New2001
D GPS message automatic transmission
q Enter “GPS AUTO TX” in DV set mode. (p. 106)
• GPS AUTO TX screen is displayed.
w Rotate [DIAL]
†
to select the desired position data trans-
mitting interval from 5 sec., 10 sec., 30 sec., 1 min., 3
min., 5 min., 10 min., 30 min. and OFF.
• The GPS message is also transmitted if programmed.
e Push [ ](5) (or [ ](4)) to return to DV SET MODE screen.
r Push [MENU/
] to return to frequency indication.
NOTE: Your own call sign (“MY”) must be set to activate
the GPS automatic transmission.
D Received GPS message indication
q Enter “RX GPS” in message/position set mode.
• RX GPS MESSAGE screen is displayed.
w Push [
](5) (or [ ](4)) to return to MESSAGE/POSITION
screen.
e Push [MENU/
] to return to frequency indication.
New
❮MENU screen❯ ➪ ❮DV SET MODE❯ ➪ ❮GPS AUTO TX❯
(Push [MENU/ ]) (Rotate [DIAL]
†
, then push [ ](5)
‡
.)
OFF
OFF
5SEC
5SEC
10SEC
10SEC
30SEC
30SEC
1MIN
1MIN
GPS AUTO TX
GPS AUTO TX
r
❮MENU screen❯ ➪ ❮MESSAGE/POSITION❯ ➪ ❮RX GPS❯
(Push [MENU/ ]) (Rotate [DIAL]
†
, then push [ ](5)
‡
.)
DATA:
DATA:
Call from
Call from
Osaka!
Osaka!
:BACK
:BACK
RX GPS MESSAGE
RX GPS MESSAGE
r
[NOTICE]
Only use GPS message automatic transmission in simplex mode.
Automatic GPS message transmission through a repeater may
interfere with other communications.
[NOTICE]
“5SEC” cannot be selected when 4 GPS sentences are selected.