EasyManua.ls Logo

Icom IC-E92D - Programming Memory;Bank;Scan Name

Icom IC-E92D
156 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
77
9
MEMORY/CALL CHANNELS
New2001
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
Programming memory/bank/scan name
Each memory channel can be programmed with an alpha-
numeric channel name for easy recognition and can be indi-
cated independently by channel. Names can be a maximum
of 8 characters.
NOTE: Scan name indication can be turned ON or OFF in
display set mode.
(p. 114)
q Push [MR] to select memory mode.
When programming a call channel name, push [CALL] to se-
lect call channel mode.
w Rotate [DIAL] to select the desired memory channel.
Select scan edge channels (0A/0B to 24A/24B) for program-
ming a scan name.
e Push and hold [S.MW](MR) for 1 sec. to enter select
memory write mode.
• 1 short and 1 long beep sound.
• Memory channel number blinks.
r Push [ ](2) or [ ](8) several times to select “BNAME,
“MNAME” or “SNAME” when programming the bank
name, the memory name or the scan name, respectively.
After selecting the name to be programmed, a cursor blinks for
the fi rst character.
t Rotate [DIAL] to select the desired character.
The selected character blinks.
Push [A/a](3) to change the character group from “AB” (alphabeti-
cal characters; capital letters), “ab” (alphabetical characters; lower
case letters), “12” (numbers) and !” ” (symbols) in sequence.
Push [ ](6) to move the cursor right; push [ ](4) to move the
cursor left.
Push [CLR](1) to erase the selected character, or push and
hold [CLR](1) for 1 sec. to erase all characters following the
cursor.
y Repeat step t until the desired channel name is pro-
grammed.
u Push and hold [S.MW](MR) for 1 sec. to program the
name and exit channel name programming.
• 3 beeps sound.
NOTE: Only one bank name can be programmed into
each bank. Therefore, the previously programmed bank
name will be displayed when bank name indication is se-
lected. Also, the programmed bank name is assigned for
the other bank channels automatically.
D Available characters
ABCDEFGHIJKLMNOPQRSTUVWXY
A B C D E F G H I J K L M N O P Q R S T U V W X Y Z
abcdefghijklmnopqrstuvwxy
a b c d e f g h i j k l m n o p q r s t u v w x y z
012345678
0 1 2 3 4 5 6 7 8 9
! '
'#$%&'()*+,-./:;<=>?@[\]
' # $ % & ' ( ) * + , - . / : ; < = > ? @ [ \ ]
^_`{|}
^ _ ` { | }
~
(Space)

Table of Contents

Other manuals for Icom IC-E92D

Related product manuals