Icom IC-E92D Instruction Manual

New
16
4
FREQUENCY AND CHANNEL SETTING
New2001
D Call/TV* channels
Call channels are used for quick recall of most-often used
frequencies.
* Appears only when TV channels are programmed via the
optional RS-92. Also available for A band operation only.
q Push [CALL] several times to select call channels/TV
channels (A band only).
• Call/TV channels can be selected in sequence.
w Rotate [DIAL] to select the desired channel.
■ Operating band selection
The transceiver can receive the AM broadcast, HF bands,
50 MHz, FM broadcast, VHF air, 144 MHz, 300 MHz, 400
MHz or 800 MHz bands.
(Some bands are not selectable for B
band operation. See next page for details.)
➥ In VFO mode, push [BAND] several times to select the
desired frequency band.
• If VFO mode is not selected, such as a memory channel/call
channel/TV channel, push [VFO] to select VFO mode fi rst, then
push [BAND] to select the desired band.
➥ While pushing and holding [BAND], rotating [DIAL] also
selects the frequency band.
[DIAL]
CALL
RX CS
C
A
MemoName
MemoName
µ
PRIO
PRIO
WX
WX
EMR
EMR
DTCS
DTCS
FM
FM
LOW
LOW
ATT
ATT
14
145
000
000
P
SKIP
SKIP
+DUP
+DUP
C0
C0
TV
TV
A
MemoName
MemoName
µ
PRIO
PRIO
WX
WX
EMR
EMR
DTCS
DTCS
WFM
WFM
LOW
LOW
ATT
ATT
10
ch
ch
P
SKIP
SKIP
+DUP
+DUP
25
25
• Call channel indication
• TV channel indication
BAND
D
[DIAL]
A
MemoNameMemoName
µ
PRIOPRIO WXWX EMREMR
DTCSDTCS
FMFM
LOWLOW
ATTATT
14144 000000
PSKIPPSKIP
+DUP+DUP
000000

Icom IC-E92D Specifications

General

Brand	Icom
Model	IC-E92D
Category	Transceiver
Language	English