New
80
9
MEMORY/CALL CHANNELS
New2001
■ Memory clearing
Contents of programmed memories can be cleared (erased),
if desired.
q Push and hold [S.MW](MR) for 1 sec. to enter select
memory write mode.
• 1 short and 1 long beeps sound.
• Memory channel number blinks.
• Do not hold [S.MW](MR) for more than 2 sec. otherwise the
memory contents will be copied to VFO.
w Rotate [DIAL] to select the desired memory channel to be
cleared.
e Push [∫](2) or [√](8) to select “CLEAR.”
r Push and hold [S.MW](MR) for 1 sec. to clear the con-
tents.
• 3 beeps sound.
• The cleared channel changes to blank channel
• Return to select memory write mode.— Memory channel
number blinks. Push [VFO] to exit select memory write mode.
NOTE: Be careful!— the contents of cleared memories
CANNOT be recalled.
14
010
BANK
:----
MNAME:
SKIP
:OFF
FM
r
000
14
000
MNAME:
SKIP
:OFF
CLEAR
r
005
FM
14
870
PSKIP
14
000
BANK
:----
MNAME:
SKIP
:OFF
r
005
BANK
:----
MNAME:
SKIP
:OFF
r
005
FM
14
870
PSKIP
VFO mode
Rotate [DIAL] to select
the desired channel.
Push and hold
for 1 sec. to clear.
Push .
Return to the VFO mode.
Enter select memory
write mode.
Push and hold
for 1 sec.
Push
to select CLEAR .
or
MR
S.MW
B
MR
S.MW
B
2
SCAN
8
TS
VFO
MHz
A
To Next Page
Loading...
Need help?
General
