47
7
DV MODE OPERATION
New2001
7
D One-touch reply using the call record
The stored call signs in the call record can be used to the
call.
q After receiving a call, push and hold [RX➝CS](CALL) for
1 sec.
Or, while pushing and holding [RX➝CS](CALL), rotate
[DIAL] to select the desired call sign record.
• Set your own call sign (MY) in advance. (p. 34)
• The call sign stored in “CALLER” is stored as “UR,” “RXRPT1” is
stored as “R2” and “RXRPT2” is stored as “R1.”
• Error beeps sound when a call sign is received incorrectly, and
no call sign is set in this case.
w Push [PTT] to transmit; release to receive.
✔For your information
When a call specifying your call sign is received, the call
signs of the calling station and the repeater it is using can be
automatically used for operation.
• When “RX call sign auto write”
(p. 101) is set to “AUTO,” the
station call sign in “CALLER” is set to “UR” automatically.
• When “Repeater call sign auto write”
(p. 101) is set to
“AUTO,” the stored station call sign in “RXRPT1” is stored
as “R2” and “RXRPT2” is stored as “R1” automatically.
1
2
3
4
5
6
8
9
10
11
12
13
14
15
16
17
18
19
DVDV
B
43439 706706
-DUP-DUP
2525
AAAAAAAAAAAA
The received call sign is displayed while pushing and
holding [CALL/RX➝CS] when [DIAL] is rotated while
[CALL/RX➝CS] is pushed.
Important!
Setting call signs with the “One-touch reply using the call
record” operation as at left are for temporary operation
only. Therefore, the set call signs will be overwritten when
another call record is used to set call signs.
• Never saved into a call sign memory.
If you want to save the set call signs, see “Copying the call
record contents into call sign memory”
(p. 50) for details.
To Next Page
Loading...
Need help?
General
