Icom IC-E92D - Page 131

123
13
OTHER FUNCTIONS
New2001
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
D Setting the YOUR and MY call signs for dig-
ital call sign squelch or beep
q Push [MAIN/DUAL] to select B band, then push and hold
[MODE](REC) for 1 sec. several times to select DV mode.
w Enter “YOUR CALL SIGN” in CALL SIGN set mode.
(p. 36)
e Rotate [DIAL]
†
to select the desired call sign.
• Input the call sign if the desired call sign is not stored in the
transceiver. See p. 36 for detail.
r Push [ ](5) to return to CALL SIGN set mode.
• Push
[
](4) to return to CALL SIGN set mode without storing
call sign.
t Rotate [DIAL]
†
to select “MY CALL SIGN” in CALL SIGN
set mode, then push [
](5)
†
to enter “MY CALL SIGN”
setting.
y Rotate [DIAL]
†
to select the desired call sign.
• Input the call sign if the desired call sign is not stored in the
transceiver. See pgs. 34 and 35 for detail.
u Push [ ](5) to set call sign and push [MENU/ ] to re-
turn to frequency indication.
❮MENU screen❯ ➪ ❮CALL SIGN❯ ➪ ❮YOUR CALL SIGN❯
(Push [MENU/ ]) (Rotate [DIAL]
†
, then push [ ](5)
‡
.)
DV VOICE M
SET MODE
r
DV SET MODE
***** MENU *****
00
200
500
r
300
DIGITAL CODE
r
CALL SIGN
RX CALL S
MESSAGE/POS
***** MENU *****
r
U01U01
ABCDEFABCDEF
500500
r
300300
YOUR CALL SIGNYOUR CALL SIGN
r
M01
GHIJKL
500
r
300
MY CALL SIGN
❮MENU screen❯ ➪ ❮CALL SIGN❯ ➪ ❮MY CALL SIGN❯
(Push [MENU/ ]) (Rotate [DIAL]
†
, then push [ ](5)
‡
.)
DV VOICE M
SET MODE
r
DV SET MODE
***** MENU *****
00
200
500
r
300
DIGITAL CODE
r
CALL SIGN
RX CALL S
MESSAGE/POS
***** MENU *****
r
U01
ABCDEF
500
r
300
YOUR CALL SIGN
r
M01M01
GHIJKLGHIJKL
500500
r
300300
MY CALL SIGNMY CALL SIGN
CAUTION!: Use digital code squelch when operating with
more than 3 stations. Because the digital call sign squelch
function recognizes “MY CALL SIGN,” the digital call sign
squelch function can be used when operating with only
one station.
NOTE:
• The tone/DTCS code squelch opens sometimes when
other stations communicate with adjacent tone frequency
or DTCS code.
• No audio sounds with S-meter swaying when receiving
signal except my call sign on DV mode .
†
[DIAL] ↔ [ ](2)/[ ](8)
‡
[ ](5) ↔ [ ](6)