Icom IC-E92D - Page 67

59
7
DV MODE OPERATION
New2001
7
1
2
3
4
5
6
8
9
10
11
12
13
14
15
16
17
18
19
◆ Playing-back and erasing the recorded audio
q Select DV mode in B band, and deactivate the priority
watch
(p. 91) if activated.
w Enter “TRACK” in DV voice memo set mode.
• TRACK screen is displayed
e Rotate [DIAL]
†
to select the desired audio track to be
played back or erased.
• “✱” is displayed beside the track number when the selected
track has been recorded.
r Push [ ](5) to play-back the recorded audio.
• Push [ ](5) again to pause, push [ ](6) to stop play-back.
t Push and hold [CLR](1) for 1 sec. to erase the recorded
audio.
y Push [
](4) to return to DV VOICE MEMO screen.
u Push [MENU/
] to return to frequency indication.
D DV auto detect
The “DV” mode indicator blinks when a non-DV signal is re-
ceived during DV mode operation.
When a signal other than DV mode is received, the IC-E92D
DV automatic detection switches to monitor in FM mode
q Enter “AUTO DETECT” in DV set mode.
(p. 106)
w Rotate [DIAL]
†
to turn the DV automatic detect function
ON and OFF.
OFF : “DV” mode indicator blinks, however the trans-
ceiver receives in DV mode even if non-DV mode
signals are received.
ON : “DV” mode indicator blinks and the transceiver
monitors the signal when receiving except DV
mode signal in FM mode.
e Push [
](5) (or [ ](4)) to return to DV SET MODE screen
r Push [MENU/
] to return to frequency indication.
NOTE: The received FM audio may be distorted when re-
ceiving an FM signal with DV automatic detect function.
❮MENU screen❯ ➪ ❮DV VOICE MEMO❯ ➪ ❮TRACK❯
(Push [MENU/ ]) (Rotate [DIAL]
†
, then push [ ](5)
‡
.)
TRACK:1
TRACK:1 *
:
:SEL
:SEL
:BACK
:BACK
CLR:CLR
CLR:CLR
TRACK
TRACK
r
❮MENU screen❯ ➪ ❮DV SET MODE❯ ➪ ❮AUTO DETECT❯
(Push [MENU/ ]) (Rotate [DIAL]
†
, then push [ ](5)
‡
.)
†
[DIAL] ↔ [ ](2)/[ ](8)
‡
[ ](5) ↔ [ ](6)