IMT CMD.CTRL - Stand Alone Crane-Compressor Activation

Stand Alone Crane 138 Section - 19
Operator’s - Manual # 99906363
Stand Alone Crane—Compressor Activation
Compressor Screen
Compressor Steps:
Engage E-Brake and start the engine.
Engage PTO (Not required if Auto PTO is congured)
Power ON Remote - RFF toggle UP and Hold for half of a second.
4. Click the LFF toggle UP to turn the Compressor ON and OFF.
☛
This is an example. Actual compressor functionality will depend on the system conguration.
Compressor will only run when the air tank pressure level is below set point.
M-STOP
1
2 3
4
01
RFF
Toggle
LFF
Toggle
When Auto PTO is
congured, the
Pop Up can be
acknowledged by
clicking Soft Toggle
2 UP.