IMT CMD.CTRL - Body-Fleet Configuration

Body Codes 143 Section - 20
Operator’s - Manual # 99906363
Body—Fleet Conguration
TO MODIFY THE FLEET CONFIGURATION SETTINGS, THE SYSTEM PASSWORD WILL
NEED TO BE ENTERED.
Note:
* is the Default option
PARAMETER OPTIONS
SUB
OPTIONS
Chassis Type None *
Ram (TYPE R1)
Ford (TYPE F1)
IPU (TYPE IPU1)
Other (TYPE OTH1)
GM/IH (TYPE GI1)
Chassis Options Paccar Engine (Other) (chassis type) indicates what chas-
sis an option is visible for.
Multiple of these options can po-
tentially be congured.
Transmission Type Automatic *
Manual
PTO Type Hot Shift *
Other
PTO Start Delay 0-10 Seconds Default is 5 Seconds
Crane Placement Right *
Left
Stabilizers Installed Left Rear No * Note: Based on Crane Placement
Front will be either Right or Left.
The sub menu will be used individ-
ually setting up each Stabilizer.
Right Rear Yes
Front Extendable
Crane Installed None * Note: The conguration to a Hy-
draulic 2nd Gen crane will happen
automatically when the Body con-
troller detects the Crane controller
on the CAN bus by receiving the
Conguration Status message
from the Crane controller.
Hydraulic
Hydraulic 2nd Gen
Electric
Electric 2nd Gen
Compressor In-
stalled
No *
Yes
Master Lock In-
stalled
No *
Yes
RPM Speeds Single *
Dual
Auto PTO Feature
Enabled
No * Note: This option will not be avail-
able when IPU Chassis or Paccar
Engine option are selected or PTO
Type is set to Other
Yes
Search Lights
Enabled
No *
Yes