Introduction 3 Section - 1
Operator’s - Manual # 99906363
Safety
READ AND UNDERSTAND THIS ENTIRE MANUAL BEFORE OPERATING, REPAIRING, OR
ADJUSTING YOUR IMT PRODUCT.
THOSE WHO USE AND MAINTAIN THIS EQUIPMENT MUST BE THOROUGHLY TRAINED AND
FAMILIAR WITH THE PRODUCT.
IF INCORRECTLY USED OR MAINTAINED, THIS EQUIPMENT CAN CAUSE SEVERE INJURY.
Always keep this manual in a location where it is readily available for persons who operate or maintain
the product. Additional copies of this manual are available from Iowa Mold Tooling Co. Inc. Please
contact IMT Technical Support Team if you require additional manuals or if you have any questions
about the information in this manual, this product, or safe operating procedures.
THESE SAFETY PROCEDURES ARE FOR YOUR OWN PROTECTION.
Do not operate this equipment until you have read its contents thoroughly. Should operators of this
equipment have a reading or learning disability, dyslexia, or other such condition, they must be
assigned a mentor/trainer to read and explain to them the entire contents of this manual as well as the
safety guidelines, danger, cautions, and warnings associated with your equipment. Such individuals
should not be allowed to operate this equipment until they thoroughly understand all of these materials.
Failure to do so can result in serious injury or death.
Refer to your S4 Telescopic Hydraulic Crane Operator’s Manual, part number 99906578, for safety
rules, procedures, operations, and maintenance schedules. Safety and safe working procedures must
be followed at all times.
SAFETY NOTICE
Follow your company’s Lock-Out/
Tag-Out procedures to prevent the
truck from being started or moved
while performing work on this
crane. If your company does not
have a Lock-Out/Tag-Out proce-
dure, follow OSHA 1910.147, Lock-
Out/Tag-Out.
SAFETY NOTICE
Use appropriate Personal Protec-
tive Equipment (PPE) as required
by your company. Read and un-
derstand the following instructions
found within this document prior to
starting work on the chassis.
To Next Page
Loading...
