Body Codes 142 Section - 20
Operator’s - Manual # 99906363
Body—Fault Code Denitions
The table below describes the categories of DTC codes for faults.
Category Description
0-0
May occur during Normal Operation and explain various interlocks. The warning icon should be
o
2-1 Indicate that there is a voltage supply problem. The warning icon on.
2-2 Indicate diculty with the inputs. The warning icon on.
2-3
Indicate that there is an output driver problem. The warning icon on. These faults shall be
latched and normal operation prevented until power is cycled.
2-4 Indicate a system is not calibrated. The warning icon on.
2-5 Indicate that a function is prevented due to a cutout. The warning icon on.
6-6
Indicate that there are system communication (CANbus) problems. The warning icon on. These
faults shall be latched and normal operation prevented until power is cycled.
9-9
Indicate that there is a controller problem. The warning icon on. These faults shall be latched
and normal operation prevented until power is cycled.
To Next Page
Loading...
