Inovance IS810N-INT Series - Page 116

- 116 -
IS810N-INT Series Servo System User Manual (Brief) Chapter 4 Wiring
b) When the host controller provides optocoupler input:
Servo drive
External 5-24 VDC
Optoco
upler
External 0 V
Servo drive
External 5-24 VDC
Optocoupler
External 0 V
No current limiting resistor
is connected
The maximum allowable voltage and current of the optocoupler output circuit inside the servo
drive are as follows:
Maximum voltage: 30 V DC
Maximum current: DC 50 mA
3) High-speed HDI4
a) Differential mode
Host controller Servo drive