Page 106 - CEAST 9340 - Instructions for Use and Maintenance 7510.000MN1r ed. 1 rev. 1
9. MAINTENANCE
9.1 SAFETY STANDARDS, GENERAL PROCEDURE
For safety reasons, arbitrary changes or
adaptations of the instrument are prohibited
X
X
X
X
X
X
The general safety norms found in the introduction of this manual are valid.
Maintenance interventions on the instrument must only be performed by MECHAN-
ICS or ELECTRICIANS, who have been specifically trained and authorized by the
SAFETY MANAGER.
Should an anomaly should be found or if operations not expressly described in this
manual are to be performed, it is necessary to contact ITW Test and Measurement
Italia S.r.l. - INSTRON CEAST Division.
Any maintenance operation on the instrument must be performed according to the
following procedure:
a) Turn off the instrument by moving the main switch to "O".
b) Open the safety switch to the mains line and remove the instrument’s electrical plug
from the wall socket.
c) Perform the maintenance operation on the instrument.
d) Visually check that the operation has been correctly performed and that the safety
shields removed have been correctly reinstalled.
e) Insert electrical plug into the wall socket and shut the safety switch on the mains line.
f) Turn on the instrument, taking care to check for any anomalies that could occur due to
errors or involuntary mistakes made during the maintenance operation.
After every maintenance, the SAFETY MANAGER is obligated to assure that the
safety conditions of the instrument and its safety shields are met.
Any work method that compromises the safety of the apparatus must be avoided.
To Next Page
Loading...
