Instron CEAST 9340 - Special-Purpose Tooling for Impact Tests on Pipes; Introduction; Supports

Page 100 - CEAST 9340 - Instructions for Use and Maintenance 7510.000MN1r ed. 1 rev. 1
8.9 SPECIAL-PURPOSE TOOLING FOR IMPACT TESTS ON PIPES
This tooling allows to carry out impact tests on pipes of thermoplastic materials according
to the ASTM D-2444 standard.
8.9.1 INTRODUCTION
8.9.2 SUPPORTS
Fig. 1 - Pipe Support 90° code 7520.212 according to ASTM D-2444 standard for
pipes diameter 80 to160 mm (to be used together with the adjustable height support
code 7520.035)
Fig. 2 - Pipe Support 90° code 7520.210 according to ASTM D-2444 standard for
pipes diameter 25 to 65 mm (to be used together with the adjustable height support
code 7520.035)
Through hole for
striker passage
WARNING !
The support is unprovided of the through hole for the striker passage therefore avoid
the impact of the striker against the support surface during the tests.