Instron CEAST 9340 - Replacement of Striker for Tensile-Impact Tests

CEAST 9340 - Instructions for Use and Maintenance 7510.000MN1r ed. 1 rev. 1 - Page 97
8.7.6 REPLACEMENT OF STRIKER FOR TENSILE-IMPACT TESTS
Authorized Personnel: Operator
X
X
DISASSEMBLY
X
a) Open the front door of the turret using the special key provided and access to the
lifting system.
b) Remove the two screws fastening the striker
c) Remove the striker from the striker holder.
X
ASSEMBLY
X
a) Open the front door of the turret using the special key provided and access to the
lifting system.
b) Place the striker against the striker holder centering the existing pins and making
sure that the plate is turned toward the front of instrument.
c) Fasten the striker with screws.
X
Striker
for
Tensile-Impact
test
Screw (x2)
Plate
Striker Holder