CEAST 9340 - Instructions for Use and Maintenance 7510.000MN1r ed. 1 rev. 1 - Page 59
Vid. 1.6.3 - “Firmware Version“
8.5.11 FW VERSION
1) “FW REV. X.XX”: number of the program version installed on the instrument.
2) “LD REV. X.XX”: number of the boot loader version.
3) “CONF. 16 - 9”: configuration of the instrument.
4) “CONF. 8 - 1”: configuration of the instrument:
“A” Environmental Chamber
“B” Striker Antirebound System
FW REV.FW REV.
FW REV.FW REV.
FW REV.
XX.XX XX.XX
XX.XX XX.XX
XX.XX
LD REV.LD REV.
LD REV.LD REV.
LD REV.
XX.XX XX.XX
XX.XX XX.XX
XX.XX
CONF.16-9CONF.16-9
CONF.16-9CONF.16-9
CONF.16-9
00000000 00000000
00000000 00000000
00000000
CONF.8-1 00000011CONF.8-1 00000011
CONF.8-1 00000011CONF.8-1 00000011
CONF.8-1 00000011
>
AB
1) “ENTER to Reset”: message for the user, pushing the
0
HOME
key the partial cycle (or tests)
counter is zeroed.
2) “Par. Cycles”: shows the number of cycles (or tests) run by the instrument prior to
zeroing.
3) “Tot. Cycles”: indicates the total number of cycles (or tests) performed by the instru-
ment.
4) “Press BACK”: return to the previous page.
Vid. 1.6.2 - “Cycle Counter“
8.5.10 CYCLE COUNTER
ENTER to ResetENTER to Reset
ENTER to ResetENTER to Reset
ENTER to Reset
PAR. CYCLESPAR. CYCLES
PAR. CYCLESPAR. CYCLES
PAR. CYCLES
XXXXXX
XXXXXX
XXX
TOT. CYCLESTOT. CYCLES
TOT. CYCLESTOT. CYCLES
TOT. CYCLES
XXXXXX
XXXXXX
XXX
Press BACKPress BACK
Press BACKPress BACK
Press BACK
>
Note: bit value: 1 installed; 0 not installed.
To Next Page
Loading...
