Instron CEAST 9340 - Abnormal Situations

Page 20 - CEAST 9340 - Instructions for Use and Maintenance 7510.000MN1r ed. 1 rev. 1
2.3 ABNORMAL SITUATIONS
ÖÖ
ÖÖ
Ö
ÖÖ
ÖÖ
Ö
ÖÖ
ÖÖ
Ö
ÖÖ
ÖÖ
Ö
ÖÖ
ÖÖ
Ö
ÖÖ
ÖÖ
Ö
ÖÖ
ÖÖ
Ö
ÖÖ
ÖÖ
Ö
ÖÖ
ÖÖ
Ö
ÖÖ
ÖÖ
Ö
ÖÖ
ÖÖ
Ö
It is absolutely necessary that the instrument be used in the conditions prescribed
in this instruction manual; no modifications to the instrument or its safeties are
permitted, nor is its use in abnormal conditions.
Below the USER is advised of a few of the recommendations to avoid abnormal
conditions of use; in any case any other condition of use that is not expressly
foreseen by this manual must be avoided.
Run the instrument only if it is installed in the prescribed position (vertical).
Avoid that people other than the operator can use the instrument while it is func-
tioning.
Do not put objects between the striker and the base plate of the turret and on the
specimen support when the instrument is running.
Do not touch the materials inside the environmental chamber during testing at
high or low temperature. Always wear thermally insulated gloves.
Do not operate the instrument if the protections are removed or not properly
fitted.
Do not remove or alter the position of the safety microswitches or the tempera-
ture sensors (with enviromental chamber only) installed on the instrument.
Do not climb on or get on top of the instrument.
Do not put material in the test chamber that differs from that prescribed (
use only
plates, films and tridimensional parts of thermoplastic materials).
Do not operate the instrument with the fixed shields dismantled or incorrectly
mounted.
Should the CUSTOMER install a tool or spare part on the instrument that has not
been supplied by ITW Test and Instrument Italia S.r.l. - INSTRON CEAST Division,
he must verify that the safety measures are maintained. Regardless, in this case
ITW Test and Instrument Italia S.r.l. - INSTRON CEAST Division does not assume
the responsibility for any eventual damages derived from the use of the afore-
mentioned part.
The instrument must not be installed or operated in a
corrosive or explosive
environment.
Do not wash the instrument with water jets or flammable materials (e.g.: diesel
fuel, gasoline, solvents, etc.).
ÖÖ
ÖÖ
Ö