CEAST 9340 - Instructions for Use and Maintenance 7510.000MN1r ed. 1 rev. 1 - Page 17
1.3 SAFETY
••
••
• The instrument is supplied with fixed and movable shields.
The fixed ones (fastened with screws) are located to the sides and rear of the turret
and rear of the environmental chamber (option) to prevent anyone accessing the
interior.
The hinge-mounted movable shields (hinge-mounted) are provided with safety
microswitches and are located at the front of turret and test chamber and allow the
operator to access the work areas for routine operations. When these shields are
opened, the safety microswitches disable operation of movable parts and heating/
cooling systems.
••
••
• The instrument is controlled by keys located on the keypad of the control box or by
the PC.
••
••
• The instrument can only be used by trained, qualified and authorized personnel.
••
••
• The responsibility for the various activities, for the operation of the instrument, must
be clearly established as indicated in the following chapter and therefore respected.
••
••
• If the electric cable is damaged or cut, it must be replaced.
••
••
• For all of the work to be done regarding: installation, start-up, tooling, use, modifica-
tion conditions of use, and work instructions, the procedures indicated in this manual
must be followed.
••
••
• This manual must always be accessible, so that it can be consulted in case of doubts
about the correct conditions of use of the instrument.
To Next Page
Loading...
